FLUKE 8505A PDF

| | 0 Comments

Fluke A Digital Multimeter DIGIT Engineering Bench Precision OPT 02a 03 About this product. About this product. Product Identifiers. BRAND. Fluke. Full text of “FLUKE A Instruction”. See other formats. Instruction Manual P/N MARCH 1 REV 1, 3/86 ®, John Fluke Mfg. Co., Inc. All Rights. Active Filter Block Diagram A Fast A/D Converter The Fast A/ D Converter employs Fluke’s patented recirculating remainder (R2) technique.

Author: Shazragore Mucage
Country: Swaziland
Language: English (Spanish)
Genre: Literature
Published (Last): 10 July 2010
Pages: 33
PDF File Size: 8.61 Mb
ePub File Size: 10.3 Mb
ISBN: 906-2-92182-611-4
Downloads: 18587
Price: Free* [*Free Regsitration Required]
Uploader: Tam

This execute character is also required if a command string longer than 31 characters is used.

Since these higher sample settings may require considerable time for a display update, this feature is necessary to insure that the operator is aware of a reading in progress. An exception occurs when a command string containing a “Get” command has fluks entered; the instrument will then respond with the value or status that was requested by the command string no reading will be triggered.

The recalled value will be displayed as long as the last push button in the sequence is fluek depressed. It does not identify the error.

  LOCATOR STRAUMANN PDF

The external reference value always measured as a dc voltage is applied as an unswitched input through the rear input connector.

A local trigger manually applied from the front panel overrides a simultaneously applied external trigger.

Fluke 8505A FOR RENT

Power Supply Removal Any carriage return or line feed following the reset character must be suppressed. Set high and low limits, Press: Specific applications using the multimeter are presented in Table The value stored at a zero input level is used as a zero correction for the selected range and for all higher ranges in the same function.

However, when Average mode is enabled, filter F is initially selected and can only be changed to F2 or re-selected. Specifications 2- 1. Error d Calibration Memory faulty or not installed. Further programming from the front panel is often not necessary. The current and ohms protection fuse 1.

An input protection fuse is bad. An indirect address requires a previous, valid direct address to set up the indirect response.

Examples of legal numeric strings are: The state of the instrument when changing from local to remote operation will fluk modified as follows: Calibration mode must be off before power-off.

Full text of “FLUKE a”

The cycle of updating each digit and annunciator and reading the switch matrix requires approximately 28 ms and is continuous. Zero may be turned off at any time.

  L7805C DATASHEET PDF

These operating features are generally compatible with the A and A multimeters. A momentary error in the buffer can be cleared by sending the G1 command or by triggering a valid reading.

Full text of “FLUKE A Instruction”

The temporary zero correction factors are applied in dc volts V or ohms Z whenever the M2 command is in effect i. Therefore, the following sequence is available: Autoranging automatically selects a range that displays the measurement with maximum resolution.

If there is any doubt concerning the line voltage setting, refer to Line Voltage Selection in Section 4. The A can only store one or the other, not both.

Controls, Indicators, and Connectors A great bench meter I recommend this meter as a good bench type meter for accurate measurement. Refer to Measurement Terminals and Controls in this Section for other uses of these selectors. Special instructions for inspection and claims are included with the shipping container.